Direction Control (1/4)

Show off your robots, circuits, chip designs, etc.

Direction Control (1/4)

Postby rkda » Fri Aug 14, 2015 11:57 pm

Here is the direction control circuit I use in my main robot.

The 4 pins on the left side are connected to the thrusters.
The two lower pin on the right determine the direction to move.
And the top right pin controls whether we are moving or not. So, I don't have to turn the power off to stop the robot.

I can stop moving, change tools, do whatever else I need to do, wire a new direction, and then start moving again. All without touching the robot power switch.

There are 4 combinations of input, and they correspond to the 4 directions of the game grid.

X Y Direction
0 0 SW
1 0 SE
0 1 NW
1 1 NE

There are other ways to arrange the logic, but this one is easy for me to remember.
If the X pin is hot, I am going RIGHT, otherwise I am going LEFT (positive or negative X)
If the Y pin is hot, I am going UP, otherwise I am going DOWN (positive or negative Y)
So, I am always moving along one of the diagonals, and in line with the game grid.

I use external logic to determine when to move, and how far. (see the 1-Shot circuit for an example)

https://drive.google.com/open?id=0B_AkMAVZUls8eE5oYllVRmVjNEk

motion-control.png
motion-control.png (255.61 KiB) Viewed 1950 times
User avatar
rkda
 
Posts: 66
Joined: Sun May 10, 2015 3:20 pm

Return to County Faire

Who is online

Users browsing this forum: No registered users and 2 guests

cron